Dark Light

BOSCH EDC16C8 (CAN bus)


STEP 1

Find 95160 EEPROM memory and unsolder it


STEP 3

Using a programmer, read the content of the ECUs EEPROM memory

Find the values in addresses from 080 – 085 (marked in blue)

Read values: 20 | 53 | 10 | B6 | E8 | 07

 ATTENTION: The picture shows example values.
These values are different in every ECU.


STEP 4

Remove 24C02 memory from S.O.S Pro Emulator


STEP 5

WRİTE these values IN REVERSE ORDER onto the 24C02 memory unsoldered from s.o.s pro emulator.


STEP 6

  Solder back the 24C02

 Use tin to bridge leg 7 and 8 of the 24C02   memory

 To choose the program you have to solder   specific jumpers on the Emulator

  (If it doesn’t work, solder jumpers 2+4+5+6 )  

 STEP 7 
 Connect the S.O.S Pro Emulator to the ECU according to the diagram below.

1. The place where you put two wires to the other site the ECU.

Using the cuting pliers cut the piece of plastic as seen on photo

Remove the piece of plastic

This hole will be use later to drive the wire through it.

Carefully put the red wire through.

Solder it to K/28 pin.

Solder the wires according to the picture above

Attention!

Disconnect antenna coil from ignition switch!


Video

Open chat
Hello 👋
Can we help you?