BOSCH EDC16C9 / EDC16C8
STEP 1
Find 95160 EEPROM memory and unsolder it
STEP 3
Using a programmer, read the content of the ECUs EEPROM memory
Find the values in addresses from 082 – 085 (marked in blue)
Read values: EB| 47 | 08 | 58
ATTENTION: The picture shows example values.
These values are different in every ECU.
STEP 4
Remove 24C02 memory from S.O.S Pro Emulator
STEP 5
WRİTE these values IN REVERSE ORDER onto the 24C02 memory unsoldered from s.o.s pro emulator.
STEP 6
Solder back the 24C02
Use tin to bridge leg 7 and 8 of the 24C02 memory
To choose the program you have to solder specific jumpers on the Emulator
(If it doesn’t work, solder jumpers 2+4+5+6 )
STEP 7
Connect the S.O.S Pro Emulator to the ECU according to the diagram below.
1. The place where you put two wires to the other site the ECU.
Using the cuting pliers cut the piece of plastic as seen on photo
Remove the piece of plastic
This hole will be use later to drive the wires through it.
Carefully put the green wire through.
Solder it to K/47 pin.
Carefully put the red wire through.
Solder it to K/28 Pin
Solder the blue wire to the capacitor as seen on photo.
Attention!
Disconnect immo box!