The Emulator can only be used in the case of ECU swap.the remaining car components, including original car key, need to be working correctly
STEP 1
Read the content of the memory
Find the values in addresses from 03C8–03CD(marked in blue)
Read values: 65 | 66 | 25 | 17 | 23 | 7C
ATTENTION: The picture shows example values.These values are different in every ECU.
STEP 2
Remove 24C02 memory from S.O.S Pro Emulator
STEP 3
Write the values from Step 2 into the 24C02 memory unsoldered from S.O.S Pro Emulator
Adresses: Text section (see picture)Values: Values from Step1.
Solder the memory back into S.O.S Pro Emulator.
STEP 4
Solder back the 24C02
Use tin to bridge leg 7 and 8 of the 24C02 memory
To choose the program you have to solder specific jumpers on the Emulator
STEP 5
Connect S.O.S pro Emulator to the ecu wiring.
make sure to secure the emulator against water
Attention : In case of cars with START/STOP system, short the starter relay!