Carefully remove the rubber coating where the memory is located
Find 95320 EEprom memory and unsolder it
STEP 2
Read the values from lines 000 in text section and remember them
ATTENTION: The picture shows example values. These values are different in every ECU.
STEP 3
Remove 24C02 memory from S.O.S Pro Emulator
STEP 4
Write the values from Step 2 in reverse order into the 24C02 memory unsoldered from S.O.S Pro Emulator
Adresses: Text section ( see picture ) Values: Values From Step 2
Solder the memory back into S.O.S Pro Emulator
STEP 5
Solder back the 24C02
Use tin to bridge leg 7 and 8 of the 24C02 memory
To choose the program you have to solder specific jumpers on the Emulator
(If it doesn’t work, solder jumpers 2+4+5+6 )
Step 6
ATTENTION: Because the ECU’s circuit boards is covered in rubber, connect the emulator to the car wiring by the ECu plugs according the pictures on the right