BOSCH ME7.3.2 / ME7.1.1 Ferrari (K-Line)
This procedure requires TWO S.O.S PRO Emulators, because there are two ECUs – SLAVE and MASTER
The ECUs are located behind the driver’s and passenger’s seats
STEP 1
Find 95160 EEPROM memory in bath ECUs and unsolder them
STEP 2
Using a programmer, read the content of the ECUs EEPROM memory
Find the values in addresses from 012 – 015 (marked in blue)
Read values: 65 | 75 | AF | 55 and remember them!
ATTENTION: The picture shows example values.
These values are different in every ECU.
You can recognise the SLAVE ECU by the XXXX values in text section of the eeprom
STEP 3
Remove 24C02 memory from S.O.S Pro Emulator
STEP 4
WRİTE these values onto the 24C02 memory unsoldered from s.o.s pro emulator.
STEP 5
Solder back the 24C02
Use tin to bridge leg 7 and 8 of the 24C02 memory
To choose the program you have to solder specific jumpers on the Emulator
(If it doesn’t work, solder jumpers 2+4+5+6 )
STEP 6
Connect the S.O.S Pro Emulator to the ECU according to the diagram below.
Attention!
Disconnect immo box which located above the driver’s legs!